Anyone use a Roland GS-24?
Posted: Sat Mar 05, 2016 2:37 pm
Hello all!
I recently purchased a Roland GS-24 to replace an older vinyl cutter. I have all my previous designs in Sure Cuts a Lot Pro 4, and would like to use the program with my new cutter, but ever time I try to run a design, the Roland GS-24 makes terrible sounds and "Error 1" pops up on the screen.
I'm about to stop using this program, and switch to the Roland CutStudio, which will be a pain, but nothing I do works. Does anyone successfully use Sure Cuts a Lot with a Roland GS-24? If so, what am I doing wrong?
Thank you!
I recently purchased a Roland GS-24 to replace an older vinyl cutter. I have all my previous designs in Sure Cuts a Lot Pro 4, and would like to use the program with my new cutter, but ever time I try to run a design, the Roland GS-24 makes terrible sounds and "Error 1" pops up on the screen.
I'm about to stop using this program, and switch to the Roland CutStudio, which will be a pain, but nothing I do works. Does anyone successfully use Sure Cuts a Lot with a Roland GS-24? If so, what am I doing wrong?
Thank you!