Craft Edge

Sure Cuts A Lot - Classroom, we created a NEW learning center for Sure Cuts A Lot that we think you may enjoy. Currently we have over 2.5 hours of video with more in the works. We start off with the basics, however, as the course progresses you get the real world applications of the effect/tool. We have many plans for this course and will release more information as time goes on.

What makes SCAL Classroom different than YouTube Videos: In this classroom, you’ll get instant access to all the videos. As more videos are released, you will have access to them as well.
[*]Organized Lessons
[*]Short Videos
[*]No Ads
[*]Exclusive Facebook Group for current SCAL Students

Go Here & watch the promo video:
http://classroom.scrappydew.com/courses ... r-training

Will these videos help with ECAL2, especially PNC?

I'm going to be honest in the fact I don't have the an eCAL machine. From the videos I seen it is laser rather than optical.

If you go to youtube and google Print and Cut Silverbullet you will find a video webinar that will help you with laser print and cut. It goes over calibration..etc. And it should be similar.

We do plan on having more videos released for this. Tracing will be covered. Print and Cut will be addressed on the machines I currently have.

Maybe Sizzix will send me a machine

A little over a year and now there is over 4 hours of videos!