Craft Edge

Posted: **Wed May 13, 2015 12:36 pm**

I am trying to import art from Silhouette (3.1.417 designer). Is the PDF route via print the only way?

Trying to cut a window in a box, yet cannot figure out how to do that.

The only mat option I appear to have is a 12" mat, yet I have a 24" cutter and mat coming. How do I change this?

Posted: **Wed May 13, 2015 2:33 pm**

for your mat size?? where it shows your mat.. go to the bottom of the back and hit custom. and type in 12x24

Posted: **Thu May 14, 2015 5:25 am**

Got it - Thanks. It figured that the 24" x 24" was a standard size for Silver Bullet, SCAL would also have that as a standard size option and I was missing it somewhere. :-/

Craft Edge

Newbie Questions: mat size, cutting out a window, and conver

Newbie Questions: mat size, cutting out a window, and conver

Re: Newbie Questions: mat size, cutting out a window, and co

Re: Newbie Questions: mat size, cutting out a window, and co