Conical Warp Feature Update

sstehman · Post by **sstehman** » Wed Jun 12, 2013 7:10 am

There was a prior topic that mentioned it would be nice if SCAL/eCAL had this feature. It is something that will be added in the future. Do not know when so we will need to watch updates for it, but did want to pass on that it is being looked at.

dragonlord666 · Post by **dragonlord666** » Wed Jun 12, 2013 10:10 am

that's good.

hope opening/importing other formats will be looked at too

Gaz

hbicigo · Post by **hbicigo** » Sat Oct 19, 2013 7:16 pm

any word on the conical wrap yet?

hbicigo · Post by **hbicigo** » Sat Oct 19, 2013 7:16 pm

any word on the conical wrap yet?

Craft Edge

Conical Warp Feature Update

Conical Warp Feature Update

Re: Conical Warp Feature Update

Re: Conical Warp Feature Update

Re: Conical Warp Feature Update