Page 1 of 1
Help with GCC cutter
Posted: Fri Mar 22, 2013 12:15 pm
by joolz218
I am trying to use SCAL 3 Pro with my GCC Expert 24 cutter...previously used it with a Silhouette without issue. Today when I attempted cutting a file, it cut it in reverse and not even close to where it should be on the vinyl in reference to origin point set up. I am running Windows 7 64 bit. I'm getting frustrated trying to figure this out. Have searched the posts and don't see anything why it would be doing this.
Thanks,
Julie
Re: Help with GCC cutter
Posted: Fri Mar 22, 2013 3:07 pm
by papasue
[quote][/quote]
check with Craft Edge support to ensure they have a version for your cutter.
Re: Help with GCC cutter
Posted: Fri Mar 22, 2013 5:14 pm
by joolz218
I did send them an email. It is listed as an option when you choose the cutter...the way it's acting is pretty weird. Haven't tried any more but three times it cut in mirror.
Re: Help with GCC cutter
Posted: Sun Sep 29, 2013 8:28 am
by themartaman
I did not get an answer either. In fact I made 2 post and neither showed up on forum. themartaman
Re: Help with GCC cutter
Posted: Sun Sep 29, 2013 3:12 pm
by themartaman
On mine the I set to Auto for connection. The only problem then is when you go to cut if the image is not farthest from cutter image it will cut in wrong place. Have not been able to get force and sped to work. Have to use VLCD for that. Test cut does not work in SCAL. Larry