Page 1 of 1
Image Placement using Cartridges
Posted: Sun Jan 06, 2013 1:10 pm
by LeslieZee
Is there someway to preview how Eclips will place images on the mat when using cartridges? I want to cut an image in 'pieces' and use different colored paper for the parts but can't tell where on the mat each will cut so I don't know how to place the paper. Any advice would be appreciated.
Re: Image Placement using Cartridges
Posted: Sun Jan 06, 2013 4:17 pm
by gj1
It sounds like you could use a video to watch, and I am just not sure where to direct you to. Perhaps the sizzix site has video how to's available, or I believe svgcuts had done some.
Re: Image Placement using Cartridges
Posted: Mon Jan 07, 2013 8:06 am
by dragonlord666
might be worth looking on the tube of U for print and cut using ecal (eclips)
I would guess it would be a very similar process