Craft Edge

I saw a similar flower on a card that I really liked, so I made my own version. Hope you like it. You might not have a problem with your machine, but I have a Cameo and my blade is getting kind of old and I noticed that slowing down the speed gave me nice clean cuts.

Gorgeous...thanks so much!

I like the design and really enjoy flowers.

Tip I've read before but haven't tried yet, but now since I have a dull blade I am going to. If you put aluminum foil on your mat and cut with your dull blade, it will sharpen the blade. Has anyone tried this?

sstehman wrote:I like the design and really enjoy flowers.

Tip I've read before but haven't tried yet, but now since I have a dull blade I am going to. If you put aluminum foil on your mat and cut with your dull blade, it will sharpen the blade. Has anyone tried this?

An urban myth I think

Nicely done design. Downloading it now to see what all three pieces together look like.

thanks for sharing it.

Thanks for the comments. Actually Papasue, I only used the loopy one. The other was left over from the design, so I decided to keep it. Here is the card I made with it which is a blatant copy of a card that was featured in Paper Crafts "Color Inspiration for Card Makers,"page 123, designed by Kim Kesti. This is one of my favor mags.

Sandy - I tried the aluminum with a Cricut blade and I don't think it made that much of a difference. I had read in lieu of cutting with aluminum, you can wad it up and run the blade across a few times. Never tried that.

Stunning design Pastda, thanks for the pic.

Here's what your design looked like with the flower, it is nice too.

Very pretty thanks for sharing!!

Everyone is loving this design...many downloads today. I thought I made one like this...so I went to look and mine is done with 8 ovals unioned together and you did yours with 9...and they look so different...I like yours better...so I have d/l'd it too! :)

thank you pasta how beautiful thank you!!!!!!