Craft Edge

I've made a design on inkscape, and have managed to convert it to a svg, but whenever I open it in SCAL 2, some of the letters have shifted. I'm at my wits end, I've gone through tutorials step by step and I'm about to scream.

Anyone that can help me, you will have my eternal gratitude. I'm desperate

Two letters got unioned together, and need to separate them.

Yes, yes, yes. thank you so very much. After 4 hours, I was about to throw the laptop out the window. Don't know what you did, but bless you.

I just took a triangle and made it narrow into a thin line and put it between the letters and went back minus front, then moved them just a smidge. Glad it worked.