Craft Edge

This was my first project.. Thought I'd share. I cut this at 7" wide and some smaller areas were still not cut fully... any smaller and it may be a PAIN!! Good luck!

good job!

dh is an nfo & I'm going to make the nfo wings for his album......some day, lol. it's on my list of things to do.

I'm currently in advanced part of flight school to be a pilot... we bought the circut on Black Friday (199 for expression with 2 fonts) to make gifts. After prying my wife off of the machine, i made the wings! If i get a chance... i'll set up an SVG of some Fo wings!

dtomcat wrote:I'm currently in advanced part of flight school to be a pilot... we bought the circut on Black Friday (199 for expression with 2 fonts) to make gifts. After prying my wife off of the machine, i made the wings! If i get a chance... i'll set up an SVG of some Fo wings!

cool! where are you at? helos or fixed wing?

I have posted some navy/military files here. Fly Navy, Semper Fi etc. I think I might have used a tomcat though.
http://forums.surecutsalot.com/viewtopic.php?f=13&t=949
http://forums.surecutsalot.com/viewtopic.php?f=13&t=841

dh flew tomcats & then transitioned to Super Hornets. he transitioned to AEDO a couple of years ago--no more deployments

I am fixed wing. I missed F/A-18's by 2 points I selected E-6's which is a boeing 707. I am at Vance AFB flying T-1's.

here is my attempt at FO wings... let me know if that will do... with this much detail i'd recommend setting it at 7".

cool!

not sure when I can try it, but It will definitely be on my computer for when I'm ready!

where did you find the clip art for it?

tfs!

I just found a picture and used inkscape. I didn't find any clickarts for military wings