Craft Edge

Does anyone know the settings for the Cricut to cut a Rhinestone template with SCAL? I have tried Blade 6 Pressure Low and Speed medium. I have the green template material for Rhinestones. Any help would be appreciated :

http://cleversomeday.wordpress.com/2009 ... ur-cricut/

Good suggestions on this page.

nmixon wrote:Does anyone know the settings for the Cricut to cut a Rhinestone template with SCAL? I have tried Blade 6 Pressure Low and Speed medium. I have the green template material for Rhinestones. Any help would be appreciated :

Where did you get the green template material? What is it's actual purpose?

What is the template material made of?

Thanks for the help. I have downloaded the fonts and will try to work with them tomorrow. Will let you know how they turned out. The template material is a kind of thin green rubber with a sticky back. I bought the starter kit at Specialty Graphics for $49.95 plus shipping. One other thing I forgot on the settings is you have to set it to Multicut x4.

Thanks again!

Nita

nmixon wrote:Thanks for the help. I have downloaded the fonts and will try to work with them tomorrow. Will let you know how they turned out. The template material is a kind of thin green rubber with a sticky back. I bought the starter kit at Specialty Graphics for $49.95 plus shipping. One other thing I forgot on the settings is you have to set it to Multicut x4.

Thanks again!

Nita

Hi I know its been a while since this thread, but I did a google search and it brought me here. Did you have to use a specialty blade ie deep housing 60/65degree? did it cut well? Sorry so many questions, just trying to understand before I make this major investment. Thanks