Craft Edge

Sign Warehouse has iron on vinyl for $12.95 a roll, 15 inches by 5 feet. Don't know if that is a super deal or not but thought I'd pass it on.

Thank you for the FYI... It is greatly appreciated!

I found the site but I wanted to add to the post that the vinyl is of the Iron-on variety for creating shirts, etc. Just a heads up in case someone is not looking for Iron-On but was looking for peel and stick or self adhesive. Either way, thank you again for the post.

Well I ordered the 5 roll pack of the Iron On Vinyl. Where I am going to put it, I don't know. Hopefully I will find a use for it.

I have been thinking about this vinyl all morning and then what comes in the mail today. My free samples and catalog from Signwarehouse. Browsing through the catalog, I see lots of things I want to order.
Getting back to my vinyl order, I have come up with about 4 ideas for which I will use this Iron on Vinyl. I can't wait until it comes.

talanhart wrote:I have been thinking about this vinyl all morning and then what comes in the mail today. My free samples and catalog from Signwarehouse. Browsing through the catalog, I see lots of things I want to order.
Getting back to my vinyl order, I have come up with about 4 ideas for which I will use this Iron on Vinyl. I can't wait until it comes.

Ohhhh you better share those photos after Todd.>LOL

I just e-mailed this for approval. They would need 36 cuts of each.

Well, I goofed. I was thinking the rolls of vinyl I ordered were 10 yards. They are only 5 ft. What was I thinking?

LOL. Not even two yards.. But the shirts look great..

hey Todd, are u using an iron or press for heat? i am going to a couple of shops tomorrow to see if they by chance have a used one they want to get rid of. keepin my fingers crossed.