Page 1 of 1
Dice design
Posted: Thu Oct 28, 2010 9:03 am
by kbarlowe1
Hi everyone!
I'm a bit of a "newbie" to the vinyl design world! I have been asked to decorate an ornament for a Bunco group and put some dice on it in vinyl. I just need a simple design of one dice (do you still call it dice if it's one?
). I like the 3D look where you can see it cubed...does that make sense? Anyone willing to share? Thanks to anyone who responds!
Kim
Re: Dice design
Posted: Thu Oct 28, 2010 9:21 am
by talanhart
Check out this topic from a previous Bunco request. This isn't one die, but three dice.
http://forums.surecutsalot.com/viewtopi ... ice#p34971
Re: Dice design
Posted: Thu Oct 28, 2010 9:51 am
by kbarlowe1
Thank you so much! I really do like that one...but the girl I am doing these for really wanted me to place several single dice on the ornament. I had considered purchasing some small beads and placing them inside of the ornament but I'm not so sure how that's gonna work with the size of the hole and being cost effective. Did I mention that I have to turn out 13!!! Yikes!
Re: Dice design
Posted: Thu Oct 28, 2010 10:28 am
by pastda3
Re: Dice design
Posted: Thu Oct 28, 2010 10:43 am
by DogCarbon
here is the first clkr image of the die that I created into a useable svg file for cutting in one piece...
Re: Dice design
Posted: Thu Oct 28, 2010 5:08 pm
by gj1
WOW, this file looks soooo clean and perfect!!! Maybe that is weird for me to say...but it just looks so perfect.
Thank you...I will use it too :)
Re: Dice design
Posted: Thu Oct 28, 2010 7:02 pm
by DogCarbon
awe...thanks... I like nice clean straight lines. That is how I design the best. Altho I like the other dice on this thread, for me, i can't design like that!
Re: Dice design
Posted: Sun Oct 31, 2010 4:35 pm
by kbarlowe1
Perfect! Perfect! Perfect! Just what I was looking for!!! Thanks so much!!!
Kim