Craft Edge

I want to cut this out of vinyl, one large piece of gray a smaller section of white and then red to overlap it. Can someone convert this into three SVG files for me?

Sorry but there is no file attached.

That's strange, I can't seem to get it to attach. If anyone is willing to help I can e-mail it to you.

LWoods wrote:That's strange, I can't seem to get it to attach. If anyone is willing to help I can e-mail it to you.

When you send a message or reply there is an option to attach/add a file , (see the below). Once you browse and find your graphic be sure you choose the add the file Option then choose the submit option. If the file is too big it will tell you. But all in all should work for you.
Hope this helps
Grammy

I keep receiving an error that the extension docx is not allowed.

What programs are supported?

attachments are usually graphics and SCAL supports both .jpg and .png files.

So if you can save your .doc as one of these or do a screen print (windows) to save as one of them you shouldn't have any problem.

Ok, thanks for the help, I will have to see what I can do and re-post then.

Thanks again!