Cut preview
Posted: Tue Feb 26, 2008 10:08 pm
This would be for when we can weld to make sure all is welded.
- Picture13.jpg (15.3 KiB) Viewed 3571 times
Page 1 of 1
Re: Cut preview
Posted: Wed Feb 27, 2008 7:39 am
Welding has to be done thru Inkscape. Once you import the .svg file into SCAL, you can tell if it is welded. If it looks like the preview on a new page in DSS, it is welded.
Re: Cut preview
Posted: Wed Feb 27, 2008 1:58 pm
Once we have welding available in SCA then I would hope we have preveiw - they kinda go hand in hand... 
Re: Cut preview
Posted: Wed Feb 27, 2008 4:34 pm
I agree. Preview a definite once you have the welding added to SCA.
I like to see what I am cutting to be sure it is what I expect.
Tiggergirl
aka Joanie
I like to see what I am cutting to be sure it is what I expect.
Tiggergirl
aka Joanie
Re: Cut preview
Posted: Wed Feb 27, 2008 10:09 pm
I don't know how to use Inkscape.
Re: Cut preview
Posted: Thu Feb 28, 2008 5:17 am
There are some posts under General that give you step by step directions to weld and make a mat/shadow using inkscape. It's very easy to use.