Page 1 of 1

reversing text

Posted: Thu Apr 22, 2010 10:54 am
by bob proulx
Can you reverse text in scal. Say I want to cut vinyl with the letters backwards so I can put them on the inside of a glass door and you can read them from the outside. I hope you can, this would be a great tool.
Bob

Re: reversing text

Posted: Thu Apr 22, 2010 10:57 am
by JenHuff
You can!! :D I believe you have to highlight the word and click on flip. I'm not looking at the program so someone correct me if I'm wrong.

Re: reversing text

Posted: Thu Apr 22, 2010 11:03 am
by bob proulx
Thanks Jen. I just tried what you said an it worked.
Bob

Re: reversing text

Posted: Fri Apr 23, 2010 11:57 am
by JenHuff
SWEET!!! I was trying to visualize doing it in my head!! LOL!

Re: reversing text

Posted: Sun Apr 25, 2010 6:38 am
by mwinkis
Where is the flip command in SCAL? Thanks!!

Re: reversing text

Posted: Sun Apr 25, 2010 2:11 pm
by bob proulx
mwinkis wrote:Where is the flip command in SCAL? Thanks!!
I think it's the first time I can help someone out on this board, usually they are helping me out. With your text or picture highlighted with the pointer tool, look to the right under appearance and it's there to the left of the weld tool.
Bob