Craft Edge

I tried to cut this for my sliding glass door. However, I was unable to manipulate the file so that the pieces were placed correcyly. I have attached a copy of the file that I have when I import it into SCAL1. I am not sure what I am doing wrong. I will look at the manual for Inkscape to see if I can figure this out. Anyway, any help would be appreciated.

Thanks

I imported it in SCAL 1. and it was all jumbeled up. So I reopened it in Inkscape .46 copied and pasted into another Inkscape page and saved it and then it imported fine in SCAL 1. I think most likely it was created in .47. I didn't however see any groups. At first I thought that was what was wrong.

Yes this was created in inkscape .47 .. sorry..

gmapatty wrote:I tried to cut this for my sliding glass door. However, I was unable to manipulate the file so that the pieces were placed correcyly. I have attached a copy of the file that I have when I import it into SCAL1. I am not sure what I am doing wrong. I will look at the manual for Inkscape to see if I can figure this out. Anyway, any help would be appreciated.

Thanks

The pieces are in the corrected place when I look at them.. This file was all created in one piece hence why you can't ungroup. only thing you can do is break apart but it will still be one rectangle not 4 squares..

Great design, thank you.