Craft Edge

Sure Cuts A Lot Forum
It is currently Thu Aug 16, 2018 4:14 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Thu Apr 12, 2018 10:01 am 

Joined: Thu Apr 12, 2018 9:48 am
Posts: 1
Hi. Can anybody possibly help me? I have purchased a Z13 from Foison (similar to the Silver Bullet cutter). When attelpting to cut multiple shapes I get a slight rotation on the cut image. I have carefully checked the rollers to ensure that they are spread uniformly along the media.


Top
 Profile  
 
PostPosted: Fri Apr 13, 2018 7:17 am 

Joined: Mon May 09, 2011 7:01 am
Posts: 352
The pinch wheels need to be centered over the grit shafts below. So pull out your mat and make sure that at least the outer two that would be near the outer edges of the cutting mat are ALSO over those grit shafts beneath.

If that's not the issue then report back your cut settings and details about the material you're cutting. By the way, you might benefit from referencing the following user manual I've written. The Maxx Air model is VERY similar to the Silver Bullet and is also made by Foison. Much of what is in this UM will probably also apply to your model.

http://www.iloveknk.com/support/knk-max ... port-page/

_________________
Sandy McCauley
Manager of Customer Relations and Education for KNK USA
Owner of http://www.iloveknk.com/


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group