when i try to cut something, it gets hung up on the initilazing phase. is there something i need to do?
i have been using SCAL2 on my old computer for years, but it would be easier if i could use it on my new computer. i can use it for design and stuff, but i can't get it to cut.
any ideas?
thanks!
moved SCAL2 to another computer and have questions
-
- Posts: 6
- Joined: Sun Jul 10, 2011 6:32 pm
Re: moved SCAL2 to another computer and have questions
Did you install the driver for your cutter onto this new computer?
Sandy McCauley
Owner of http://www.iloveknk.com/
Owner of http://www.iloveknk.com/
-
- Posts: 6
- Joined: Sun Jul 10, 2011 6:32 pm
Re: moved SCAL2 to another computer and have questions
no, probably not. i watched a youtube video on how to do it, but i wasn't able to follow the directions.
-
- Posts: 6
- Joined: Sun Jul 10, 2011 6:32 pm
Re: moved SCAL2 to another computer and have questions
ok, i went to the craftedge site and downloaded the 2.4.2 usb driver package. installed it. tried it and the same thing happened. any other ideas or things i can check to see if i did it right or have what i need?
thank you for your help.
thank you for your help.
Re: moved SCAL2 to another computer and have questions
It's not easy to know what to say without verification of which cutter you even own. Or which operating system you're using on your computer. Maybe provide a lot more information and someone can give you better suggestions. I only use SCAL4 myself, but since this is tied to the driver, it should be more about the cutter and computer bands/models.
Sandy McCauley
Owner of http://www.iloveknk.com/
Owner of http://www.iloveknk.com/