Craft Edge

Cutting Lines With SureCut Pro
Page 1 of 1

Author:  kaoneal [ Tue Jun 09, 2015 5:46 pm ]
Post subject:  Cutting Lines With SureCut Pro

I just purchased a USCutter Titian 15" table top cutter and was advised to get help her on what speed and force to use when cutting iron on glitter vinyl. I can barley see the lines after it is cut. I have even double cut. Any help with be great as to what to set my Speed and Force on. Thanks in advance

Author:  MuzzyMonkeys [ Sun Jul 17, 2016 10:46 am ]
Post subject:  Re: Cutting Lines With SureCut Pro

You have probably already figured this out by now...

I have a Titan and I cut glitter vinyl at 200g force and speed anywhere from 200-450
This really all depends on your blade depth being set correctly though.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group