Craft Edge

Sure Cuts A Lot Forum
It is currently Mon Oct 21, 2019 8:15 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Tue Jun 09, 2015 5:46 pm 

Joined: Tue Jun 09, 2015 5:40 pm
Posts: 1
I just purchased a USCutter Titian 15" table top cutter and was advised to get help her on what speed and force to use when cutting iron on glitter vinyl. I can barley see the lines after it is cut. I have even double cut. Any help with be great as to what to set my Speed and Force on. Thanks in advance


Top
 Profile  
 
PostPosted: Sun Jul 17, 2016 10:46 am 

Joined: Sun Jul 17, 2016 7:56 am
Posts: 1
You have probably already figured this out by now...

I have a Titan and I cut glitter vinyl at 200g force and speed anywhere from 200-450
This really all depends on your blade depth being set correctly though.


Top
 Profile  
 
PostPosted: Thu Aug 08, 2019 6:27 am 

Joined: Mon Jul 29, 2019 3:53 pm
Posts: 5
Location: Panama
Hi, I have some problems with cutting on DC4SX. Ive done every kind of calibration and nothing helps. Ive changed the knife, and knife holder to new one. Plotter still doesnt cut straight on contour lines cuts are quite off the lines Does anyone have any suggestions how to fix this problem, is it hardware or software issue ?


Top
 Profile  
 
PostPosted: Fri Aug 09, 2019 7:22 am 

Joined: Mon May 09, 2011 7:01 am
Posts: 692
It sounds like a cutter issue. What material are you cutting? When you calibrated did you get a perfect contour cut after that? Are you cutting many shapes on a single sheet or one single contour cut? Some photos would be very helpful.

_________________
Sandy McCauley
Owner of http://www.iloveknk.com/


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group