New eclips2 cutting half an inch to the left

Post Reply
kendium
Posts: 2
Joined: Wed Mar 02, 2011 1:27 pm

New eclips2 cutting half an inch to the left

Post by kendium »

Just replaced my old Sizzix eclips 2 with a new Sizzix eclips 2. Plugged it in and it is cutting half an inch to the left of what my computer screen shows? I am using Sure cuts a lot. Any help fixing this would be greatly appreciated.
SandyMcC
Posts: 1114
Joined: Mon May 09, 2011 7:01 am

Re: New eclips2 cutting half an inch to the left

Post by SandyMcC »

I'm not an eclips user but in general, when this happens with any cutter, it's based on what that cutter uses as a pointer for setting the origin. For example, if a cutter has a laser light, then that laser light is usually used to determine where the origin is set for a cut. If the cutter doesn't, then it's usually the location of the blade tip.
Sandy McCauley
Owner of http://www.iloveknk.com/
Post Reply