Aligning mat?

Post Reply
scraperfect
Posts: 30
Joined: Fri Jun 27, 2008 8:29 am

Aligning mat?

Post by scraperfect »

It's cutting about 3/4 inch to the left of where it is supposed to be. I JUST calibrated the laser and origin. Maybe calibration was done wrong...Any ideas?

THANKS!
Offset Issue.jpg
Offset Issue.jpg (302.15 KiB) Viewed 4485 times

(PS the Ecal2 mat image numbers from 1 at top to 12 at bottom, whereas the actual physical mat numbers from 12 at top to one at bottom....)
Have a Magically Perfect Day! www.ScraPerfect.com
scraperfect
Posts: 30
Joined: Fri Jun 27, 2008 8:29 am

Re: Aligning mat?

Post by scraperfect »

I just re-aligned the mat and it seems to be working fine!
Have a Magically Perfect Day! www.ScraPerfect.com
Post Reply