Aligning mat?
Posted: Tue Dec 19, 2017 12:55 pm
It's cutting about 3/4 inch to the left of where it is supposed to be. I JUST calibrated the laser and origin. Maybe calibration was done wrong...Any ideas?
THANKS!
(PS the Ecal2 mat image numbers from 1 at top to 12 at bottom, whereas the actual physical mat numbers from 12 at top to one at bottom....)
THANKS!
(PS the Ecal2 mat image numbers from 1 at top to 12 at bottom, whereas the actual physical mat numbers from 12 at top to one at bottom....)