Craft Edge
http://forum.surecutsalot.com/

Aligning mat?
http://forum.surecutsalot.com/viewtopic.php?f=86&t=42773
Page 1 of 1

Author:  scraperfect [ Tue Dec 19, 2017 12:55 pm ]
Post subject:  Aligning mat?

It's cutting about 3/4 inch to the left of where it is supposed to be. I JUST calibrated the laser and origin. Maybe calibration was done wrong...Any ideas?

THANKS!
Attachment:
Offset Issue.jpg
Offset Issue.jpg [ 302.15 KiB | Viewed 307 times ]



(PS the Ecal2 mat image numbers from 1 at top to 12 at bottom, whereas the actual physical mat numbers from 12 at top to one at bottom....)

Author:  scraperfect [ Tue Dec 19, 2017 5:15 pm ]
Post subject:  Re: Aligning mat?

I just re-aligned the mat and it seems to be working fine!

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/