|Page 1 of 1|
|Author:||scraperfect [ Tue Dec 19, 2017 12:55 pm ]|
|Post subject:||Aligning mat?|
It's cutting about 3/4 inch to the left of where it is supposed to be. I JUST calibrated the laser and origin. Maybe calibration was done wrong...Any ideas?
Offset Issue.jpg [ 302.15 KiB | Viewed 528 times ]
(PS the Ecal2 mat image numbers from 1 at top to 12 at bottom, whereas the actual physical mat numbers from 12 at top to one at bottom....)
|Author:||scraperfect [ Tue Dec 19, 2017 5:15 pm ]|
|Post subject:||Re: Aligning mat?|
I just re-aligned the mat and it seems to be working fine!
|Page 1 of 1||All times are UTC - 8 hours|
|Powered by phpBB® Forum Software © phpBB Group