Craft Edge

Sure Cuts A Lot Forum
It is currently Tue Nov 20, 2018 2:31 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Aligning mat?
PostPosted: Tue Dec 19, 2017 12:55 pm 

Joined: Fri Jun 27, 2008 8:29 am
Posts: 30
It's cutting about 3/4 inch to the left of where it is supposed to be. I JUST calibrated the laser and origin. Maybe calibration was done wrong...Any ideas?

THANKS!
Attachment:
Offset Issue.jpg
Offset Issue.jpg [ 302.15 KiB | Viewed 923 times ]



(PS the Ecal2 mat image numbers from 1 at top to 12 at bottom, whereas the actual physical mat numbers from 12 at top to one at bottom....)

_________________
Have a Magically Perfect Day! www.ScraPerfect.com


Top
 Profile  
 
 Post subject: Re: Aligning mat?
PostPosted: Tue Dec 19, 2017 5:15 pm 

Joined: Fri Jun 27, 2008 8:29 am
Posts: 30
I just re-aligned the mat and it seems to be working fine!

_________________
Have a Magically Perfect Day! www.ScraPerfect.com


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group