Laser turns off at the second registration mark
Laser turns off at the second registration mark
When I am aligning the regisration marks everything works as it should for the first one. But, when I move to the second one the laser turns off and will not come back on. I see that one other person has had this issue, but no solution was given in their thread. Is there a known fix for this?
Re: Laser turns off at the second registration mark
What cutter are you using with what vs of SCAL?
Susan E
http://creationsbypapasue.blogspot.com
LEARN, GROW, CREATE, SHARE
Mac 10.12.6 Sierra, eCAL 1.506, ECAL2.023, SCAL4Pro, Export Plug-in, Inkscape 48, iPad/scal3
eClips2.
http://creationsbypapasue.blogspot.com
LEARN, GROW, CREATE, SHARE
Mac 10.12.6 Sierra, eCAL 1.506, ECAL2.023, SCAL4Pro, Export Plug-in, Inkscape 48, iPad/scal3
eClips2.
-
- Posts: 79
- Joined: Wed Mar 07, 2012 5:48 pm
- Location: Ohio
Re: Laser turns off at the second registration mark
I'm assuming you are using an eclips!?
There is a tiny rectangular box located on the back of the machine. Approaching the machine from the back, you will see a long horizontal opening for the mat. If you look all the way to the right on the horizontal opening you will see the black rectangular box. Using a clean Q-Tip, brush off any dust left from your paper cuttings. Hopefully this will solve your problems.
There is a tiny rectangular box located on the back of the machine. Approaching the machine from the back, you will see a long horizontal opening for the mat. If you look all the way to the right on the horizontal opening you will see the black rectangular box. Using a clean Q-Tip, brush off any dust left from your paper cuttings. Hopefully this will solve your problems.