Craft Edge

Sure Cuts A Lot Forum
It is currently Fri Nov 16, 2018 7:23 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Error code 5????
PostPosted: Sun Mar 24, 2013 11:28 am 

Joined: Mon Mar 07, 2011 8:51 am
Posts: 124
Because I was running into so much interfernce on my desk top with ecal software (ie: itunes makes ecal stop in middle of cutting, wireless keyboard doesn't work when using ecal), we decided to try running ecal on my husbands laptop.
This is the error code I got:
c:program files (x86) craftedge\ecal\ecal.exe.
An error occured while trying to replace the existing file: Delete file failed; code5 Access denied.

Is this because I can't have it activated on my desktop and my laptop?
if that is the case, how do I deactivate it on the desk top?

Grrrrr.....not getting much done lately.
:cry:


Top
 Profile  
 
 Post subject: Re: Error code 5????
PostPosted: Sun Mar 24, 2013 4:37 pm 

Joined: Wed Dec 01, 2010 4:29 pm
Posts: 1964
Location: Sandy in PA (PC&MAC,Inkscape .48, SCAL2,eClips, eCAL)
You may install it on a desktop and on a laptop. Do a complete un-install on the laptop and then re-install again. I've never had an installation issue on any of the versions and I have both PC and Mac versions.

_________________
Sandy in PA


Top
 Profile  
 
 Post subject: Re: Error code 5????
PostPosted: Mon Mar 25, 2013 6:16 am 

Joined: Mon Mar 07, 2011 8:51 am
Posts: 124
Thank you. I did get it installed. I appreciate your taking the time to answer!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group