Craft Edge

Sure Cuts A Lot Forum
It is currently Wed Nov 14, 2018 7:06 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Sep 23, 2012 8:48 am 

Joined: Sun Sep 23, 2012 8:41 am
Posts: 1
Hi
I am very very new and I have a question. I have a cougar machine and when I send to cut print and cut, my cutting mat is just pushed out of the machine - and I do not know why.
I would be most grateful if someone could tell me. The cutting mat is in the correct place and locked down as it should be.
thank you


Top
 Profile  
 
PostPosted: Sun Sep 23, 2012 9:44 am 

Joined: Sun Jul 22, 2012 2:54 am
Posts: 124
Location: Wandsworth, London
Hi

This often happens when you are cutting too close to the edge of the mat, the pinch wheels loose their grip on the mat and the mat shoots out

I turn my mat by 90 degrees and find that helps - be careful to ensure that your mat can move back and forwards without losing grip

If in doubt set up your media on the mat and lift the blade assembly so it doesnt cut then test - keep on doing that till you have the mat where it holds then replace the blade at the correct level and off you go

good luck
Pandora :)

_________________
Win7, SCAL3.044, Silver Bullet 18" Craft Artist Pro, Photoshop,


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group