Cutter drag problem

Post Reply
rosamond
Posts: 3
Joined: Mon Jul 02, 2012 12:42 pm

Cutter drag problem

Post by rosamond »

I am a new user of the Eclips machine. While cutting out designs using Ecal, I am getting lots of blade drag where it's not wanted!! If I decrease the blade number and pressure, the design doesn't cut all the way around. But even at that, I can see where the blade seemed to drag just a little across the paper. Does anyone have a suggestion?

Thanks.
gj1
Posts: 4465
Joined: Mon Oct 12, 2009 5:01 am

Re: Cutter drag problem

Post by gj1 »

This post speaks to this situation...perhaps you can contact sizzix.

viewtopic.php?f=84&t=26778
My pictures and files are available for a limited time only.
mitsim
Posts: 462
Joined: Sat Nov 26, 2011 1:32 pm
Location: SoCal (Windows 7, Eclips1, ECAL 1.500, Photoshop, Illustrator

Re: Cutter drag problem

Post by mitsim »

Probably need to contact Sizzix. The only other thing I can think of is to make sure the sensor in the back left, where the mat/paper comes out the back, is clean, and that the mat is not bowed at all. If it is bent or bowed, it could cause this problem.
Post Reply