Craft Edge

Sure Cuts A Lot Forum
It is currently Sat May 27, 2017 11:30 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 11 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: Fri Jun 26, 2015 10:08 am 

Joined: Fri Jun 26, 2015 9:52 am
Posts: 1
I had the same problem with a 1st Gen Sizzix Eclips machine that I purchased and received yesterday. Finally, after 3-4 hrs I fiddled with the two red buttons on the inside. The left button :shock: was stuck and very tight.I had to work it a loose. Once it loosened up I held both left and right buttons and the unit reset. Problem solved!!! :D


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 11 posts ]  Go to page Previous  1, 2

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group