Craft Edge

Gazelle - old model
Page 1 of 1

Author:  jenncashion [ Sat Jun 09, 2018 4:21 am ]
Post subject:  Gazelle - old model

Will the Sure Cuts A Lot work with my Bosskut Gazelle? It is around 9 years old and during a recent move, lost the funtime program and don't remember my password. Thought it was time to get a better program anyway. The Funtime and Gazelle, at least the older versions that I have, never was easy to work with anyway.

Author:  SandyMcC [ Sun Jun 10, 2018 6:12 am ]
Post subject:  Re: Gazelle - old model

I just checked inside SCAL4 and the Bosscut Gazelle is an available cutter option to choose. Maybe try downloading the trial version of SCAL4 at the link below and trying it out. There's a 15 day trial period in which you'll be able to test it. There will be watermark cuts added to anything you send to the cutter and I believe there could be a few other functions not available. But you should be able to see if you feel it would be a good choice for you. Feel free to post back if you have any questions about SCAL4.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group