Cameo 3 Cutting Problem

Discuss various cutting machines for SCAL
Post Reply
The Cynergist
Posts: 15
Joined: Fri Aug 24, 2012 1:07 pm

Cameo 3 Cutting Problem

Post by The Cynergist »

I've been doing some test cuts with my new cameo, and so far I'm impressed with the quality of the cuts. I do have an issue with cutting text though. Some parts of the text placed near the top margin doesn't cut at all. It's as if the cutter doesn't even see it. Images are fine when placed at the top, but for some reason it just doesn't work with text.

The firmware is up to date and so is the software. I'm using cameo 3 and SCAL 4. The margins are 1/4 inch. I'd rather not have to move my designs down to accommodate this problem. Has anyone else experienced this and know what to do to fix it?

The image attached illustrates the issue. The top line of text reads Healing prayer.
IMG_0545.JPG (1.55 MiB) Viewed 1646 times

Post Reply