Craft Edge
http://forum.surecutsalot.com/

How to printing vertical?
http://forum.surecutsalot.com/viewtopic.php?f=85&t=41707
Page 1 of 1

Author:  bigbadbrock [ Sun Jun 05, 2016 9:01 am ]
Post subject:  How to printing vertical?

I am trying to print a banner and I can not get my Laser point 2 to print vertical using Sure Cuts A Lot Pro 3! Any help would be appreciated

Author:  papasue [ Sun Jun 05, 2016 5:25 pm ]
Post subject:  Re: How to printing vertical?

Did you try rotating the design to a vertical orientation?

Author:  bigbadbrock [ Mon Jun 06, 2016 6:20 pm ]
Post subject:  Re: How to printing vertical?

Yes I went into objects and turned it vertical but it prints horizontal.

Thanks, Bobby

Author:  papasue [ Fri Jun 10, 2016 11:00 am ]
Post subject:  Re: How to printing vertical?

Are you sure that you have your mat orientation and print set correctly? When you dos print preview does it look correc

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/