Craft Edge

Troubleshoot Redsail
Page 1 of 1

Author:  HopeRaiser [ Fri Jan 05, 2018 9:42 pm ]
Post subject:  Troubleshoot Redsail

I am not new to vinyl cutting but I am new to Sure Cuts A Lot and my new RedSail cutter. It was working fine for a couple prints then it started to only cut parts and just stop cutting. It seems like a USB issue but I have tried multiple machines and I am getting the same issue.

Author:  SandyMcC [ Sat Jan 06, 2018 11:26 am ]
Post subject:  Re: Troubleshoot Redsail

Can you try your project again and when it stops, take a photo showing the entire cutter so that I can see where the head is located when it stops. Please post that photo here.

Author:  Cosmo88 [ Wed Jan 17, 2018 7:41 pm ]
Post subject:  Re: Troubleshoot Redsail

Thank you. I will open it when I get home.


Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group