Craft Edge
http://forum.surecutsalot.com/

24" Max length X 12" Width Using...
http://forum.surecutsalot.com/viewtopic.php?f=84&t=42711
Page 1 of 1

Author:  ScaleAero [ Fri Nov 17, 2017 12:48 pm ]
Post subject:  24" Max length X 12" Width Using...

Not to sound as if I have not read the technical documentation and watched the video support,
but is the max cut depth in the double cut pad (around 22 inches because of the additional
perimemter clear zone requirement.). This is said to permit a continuous cut edge 24" sans the
amount stated above.

One would think after five and one half years I would have satisfied all my questions... :) Well
for all the mistated promises made by salesmen preceding this purchase, this time I am going to
either buy nothing or the Eclips2 with eCAL2.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/