Craft Edge

Sure Cuts A Lot Forum
It is currently Wed Dec 13, 2017 8:08 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Fri Nov 17, 2017 12:48 pm 

Joined: Wed Feb 01, 2012 10:19 am
Posts: 8
Not to sound as if I have not read the technical documentation and watched the video support,
but is the max cut depth in the double cut pad (around 22 inches because of the additional
perimemter clear zone requirement.). This is said to permit a continuous cut edge 24" sans the
amount stated above.

One would think after five and one half years I would have satisfied all my questions... :) Well
for all the mistated promises made by salesmen preceding this purchase, this time I am going to
either buy nothing or the Eclips2 with eCAL2.

_________________
ScaleAero


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group