Page 1 of 1

Eclips2 not cutting all the way through paper

Posted: Wed Nov 08, 2017 7:56 am
by cvilleartist
I've been using my eclips2 for about 3 years- relatively heavily. I primarily use 110- 120 lb card. Lately with even a new blade it's not cutting all the way through the paper consistently. The work is quite detailed, but it has handled it fine till now. Would a new blade holder be an appropriate fix? I'm using level 6 on the holder and 9 pressure, unsure of my options here.

Re: Eclips2 not cutting all the way through paper

Posted: Wed Nov 08, 2017 4:53 pm
by papasue
Yes a new blade holder..if it does not work I think u can return it, but check with Sizzix first .

Re: Eclips2 not cutting all the way through paper

Posted: Thu Nov 09, 2017 9:01 am
by SandyMcC
Check the stickness of the cutting mat. If the cardstock isn't properly and completely stabilized, then those areas will not cut.