need help with reg marks
Posted: Sun Jun 25, 2017 5:30 pm
Tonight I was trying to use 4x6 in photo paper with several different small images grouped on the paper. I could not get the software to allow a print without the warning that I was too close to the edge for the reg marks to print even though on the second printing all three reg marks printed.
I would like to group as close to permitted margins as possible to get as many images cut as possible
Several questions, first the offset mark setting is set for 64 cm. What Is this from. Is it the edge of the paper or the mat or the size of the paper loaded to print and cut How can I know where the reg mark should print . Do i need to change the default to a different setting.
Does the software understand small paper sizes like 4x6in from the epson print driver. Lot of questions at on sitting
I have been doing small cutouts and wanted to work with small papers (4x6) to save paper.
There again since I'm still learning, it might be something I have overlooked. Thanks for any help Wyndham
I would like to group as close to permitted margins as possible to get as many images cut as possible
Several questions, first the offset mark setting is set for 64 cm. What Is this from. Is it the edge of the paper or the mat or the size of the paper loaded to print and cut How can I know where the reg mark should print . Do i need to change the default to a different setting.
Does the software understand small paper sizes like 4x6in from the epson print driver. Lot of questions at on sitting
I have been doing small cutouts and wanted to work with small papers (4x6) to save paper.
There again since I'm still learning, it might be something I have overlooked. Thanks for any help Wyndham