Craft Edge
http://forum.surecutsalot.com/

Sure Cuts A Lot 4 Released for Windows & Macintosh
http://forum.surecutsalot.com/viewtopic.php?f=84&t=40676
Page 5 of 5

Author:  suncast [ Fri Jun 02, 2017 8:00 am ]
Post subject:  Re: Sure Cuts A Lot 4 Released for Windows & Macintosh

Hi,

Do you know when you expect to make SCAL4 Compatible with the new Mac Operating System MaxOS Sierra Version 10.12.5 ?
My designs/shapes are way off. The WYSWYG is off, cutting point is off. Weld is off, erasing is off etc.
Thank you.

Author:  kmack [ Wed Sep 20, 2017 2:53 pm ]
Post subject:  Re: Sure Cuts A Lot 4 Released for Windows & Macintosh

hi there;

I just purchased this program to run my USCutter SC24, but I cannot get the 2 to talk to each other. I've installed the FTDI usb driver, and have successfully installed the SCAL4 application. Is there something else that I am missing? Any and all help is greatly appreciated.

Thanks

Author:  papasue [ Wed Sep 20, 2017 3:53 pm ]
Post subject:  Re: Sure Cuts A Lot 4 Released for Windows & Macintosh

Have u checked the us cutter folks or their forum? Also send support request to support@craftedge.com

Page 5 of 5 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/