Print and CUt Registration Marks
Print and CUt Registration Marks
I am hopeful someone can help me out. I have ECAL software for my Eclips machine. I cannot for the life of me get the registration marks to get in the margins. I even put my design in the center of the page and no luck. I am only trying to print an image that is 4x4 inches, I have the mat set to 12x12 and the paper set to 12x12.
Re: Print and CUt Registration Marks
Susan E
http://creationsbypapasue.blogspot.com
LEARN, GROW, CREATE, SHARE
Mac 10.12.6 Sierra, eCAL 1.506, ECAL2.023, SCAL4Pro, Export Plug-in, Inkscape 48, iPad/scal3
eClips2.
http://creationsbypapasue.blogspot.com
LEARN, GROW, CREATE, SHARE
Mac 10.12.6 Sierra, eCAL 1.506, ECAL2.023, SCAL4Pro, Export Plug-in, Inkscape 48, iPad/scal3
eClips2.
-
- Posts: 3913
- Joined: Sun Jan 11, 2009 7:16 am
- Location: Michigan, SCAL1; SCAL2; eCAL; Windows7 64 bit; eCAL Mavericks
- Contact:
Re: Print and CUt Registration Marks
If you have your virtual mat set to Vertical (Portrait) orientation then the upper left corner (with the black triangle) prints is the upper left corner of your paper. I don't remember how it prints in the other orientation.
You can change your registration marks if you wish so that they are closer to your cut lines. I have my mark offset set at 0.10 cm so that I can fit more digi stamps on my cardstock.
Another thing to check is to use the cut preview button (magnifying glass over page icon) to see if you have a stray cut line or node that is causing the marks to be out farther than expected.
You can change your registration marks if you wish so that they are closer to your cut lines. I have my mark offset set at 0.10 cm so that I can fit more digi stamps on my cardstock.
Another thing to check is to use the cut preview button (magnifying glass over page icon) to see if you have a stray cut line or node that is causing the marks to be out farther than expected.