Craft Edge

Sure Cuts A Lot Forum
It is currently Tue Aug 20, 2019 3:50 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Ecal3
PostPosted: Tue Jul 30, 2019 4:07 pm 

Joined: Tue Jul 30, 2019 4:04 pm
Posts: 2
I have sent several emails to customer support, over issues with the Ecal 3.005, to no reply. Is the program no longer being updated or supported by Craftedge? :?:


Top
 Profile  
 
 Post subject: Re: Ecal3
PostPosted: Wed Jul 31, 2019 12:34 pm 

Joined: Mon May 09, 2011 7:01 am
Posts: 635
The owner of Craft Edge had an accident early this month and is probably behind on support tickets. Maybe post your issues here and I'll see if I can help you. If not, then I'll forward them, on your behalf to Craft Edge.

_________________
Sandy McCauley
Owner of http://www.iloveknk.com/


Top
 Profile  
 
 Post subject: Re: Ecal3
PostPosted: Thu Aug 01, 2019 3:24 am 

Joined: Tue Jul 30, 2019 4:04 pm
Posts: 2
Thank you Sandy, I wasn't aware of the accident. I pray for a speedy recovery. Thank you for your offer of support, but the issues are not limited to one issue, and covers several issues that others are experiencing as well.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group