Craft Edge

Sure Cuts A Lot Forum
It is currently Fri Sep 22, 2017 7:38 pm

All times are UTC - 8 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Bit of a de..lem...a
PostPosted: Thu Jul 13, 2017 7:47 am 

Joined: Sun May 21, 2017 8:58 am
Posts: 18
Don't understand what just happened
I created a project 6 diamond about 1/2 in point to point I grouped them filled each with a pattern and printed it on 3x5 in card stock with reg marks set at .10 Printed out on my epson 2200 w/ min margins. Printed fine.
I saved the project "6diamond narrow" but I did not cut at the time. Next day when I had the time, I opened the project for printing but I noticed the paper size was reset to 8.5x11 so I reset it to the3x5 margins. I went to P&C into setting up my reg points(3) With this set I went to cut. The cut was inside each diamond not on the cut lines in the preview.

Has this happened to others, did I unknowingly change something that caused this issue, is it a known issue or did I find a bug. I have done similar cuts but it's the first time I printed, saved, closed the project then next day start up and did a cut from a previous days work.
Thanks Wyndham


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group