leading and trailing lines

Post Reply
taz
Posts: 1
Joined: Fri Mar 06, 2020 6:08 pm

leading and trailing lines

Post by taz »

SCALP5 octagon
SCALP5 octagon
SCAL5P1.PNG (12.26 KiB) Viewed 843 times
Easy cut octagon
Easy cut octagon
EasyCut.PNG (9.1 KiB) Viewed 843 times
Basic arrow
Basic arrow
SCAL5P2.PNG (22.14 KiB) Viewed 843 times
I just switched from Easy Cut to SCALP5. everything looks ok until I go to cut or draw. depending on the item I get leading and trailing lines. I have overcut set to 0. in SCAL5P2 the pen goes from start point to the 5 cutting through the arrow, on the Octagon it is leading and trailing cuts.
Anyone know if there is a setting or adjustment somewhere. (ignore the size difference. I didn't think to make exact size, but doesn't matter.)
This example is with a pen, because I already ruined a decal...

Using Saga cutter

SandyMcC
Posts: 827
Joined: Mon May 09, 2011 7:01 am

Re: leading and trailing lines

Post by SandyMcC »

Even though you responded on Facebook that you figured it out, I thought I'd go ahead and answer here what you discovered. There are two Saga cutters available in SCAL's menu of cutters: Saga and Saga ARMS. The wrong one was selected in SCAL.
Sandy McCauley
Owner of http://www.iloveknk.com/

Post Reply