Craft Edge
http://forum.surecutsalot.com/

Multiple cut depths on one cut? Is that possible for Die Cut
http://forum.surecutsalot.com/viewtopic.php?f=81&t=43149
Page 1 of 1

Author:  cglodt [ Sun Jul 08, 2018 5:47 pm ]
Post subject:  Multiple cut depths on one cut? Is that possible for Die Cut

I am wanting to cut a sticker but then also cut the sticker out completely through the vinyl and paper backing. Is that possible? It would be like creating a die cut sticker where its fully cut out with the backing intact.

I am using SCAL4 to cut on my Titan 2 Cutter.

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/