Help needed Print & Cut KNK MAXX
Posted: Sat Jan 20, 2018 1:47 pm
I have an old KNK MAXX that has been given a new lease on life since I purchased SCAL 4 Pro. This morning I decided to give cut and print a try with absolutely NO success.
After over an hour of carefully calibrating the laser-blade distance within the software and precisely hitting all three registration marks, the cut was off by 2mm vertically/Y-axis and 11 mm horizontally/X-axis). Unclear what went wrong, but it was VERY frustrating.
Wondering if there is just no point in trying to print and cut with this older machine. It's due to be retired (possibly to metal recycling) and replaced fairly soon.
Any advice greatly appreciated.
After over an hour of carefully calibrating the laser-blade distance within the software and precisely hitting all three registration marks, the cut was off by 2mm vertically/Y-axis and 11 mm horizontally/X-axis). Unclear what went wrong, but it was VERY frustrating.
Wondering if there is just no point in trying to print and cut with this older machine. It's due to be retired (possibly to metal recycling) and replaced fairly soon.
Any advice greatly appreciated.