Blade travel to right edge after each cut makes things slow
Posted: Thu Jun 08, 2017 7:37 am
Since upgrading to SCAL 4 Pro, my USCutter SC cutter is doing something strange. In a complex design, it will make a simple cut of one small item, then the blade will return all the way to the right edge of the material, then it will travel back and make the next cut and then return to the right edge again. It does this for almost all the cuts. This REALLY slows things down.
This did not happen in SCAL 3, so I'm guessing there's something new in SCAL 4 Pro, and I need to now do things differently to get a more efficient cut. Any help you can provide with this?
Thanks!
This did not happen in SCAL 3, so I'm guessing there's something new in SCAL 4 Pro, and I need to now do things differently to get a more efficient cut. Any help you can provide with this?
Thanks!