After doing at auto-scan, SCAL3 locks up. It's happened both times I was able to do a sucessful auto-scan of the registration marks.
To be precise, it doesn't lock up until I click "OK" on this little popup:
Print and Cut: Software locks up after successful auto-scan
-
papercruiser
- Posts: 23
- Joined: Tue Nov 27, 2012 2:03 pm
Print and Cut: Software locks up after successful auto-scan
I have SCAL3 and the Black Cat Pro.
After doing at auto-scan, SCAL3 locks up. It's happened both times I was able to do a sucessful auto-scan of the registration marks.
To be precise, it doesn't lock up until I click "OK" on this little popup:
After doing at auto-scan, SCAL3 locks up. It's happened both times I was able to do a sucessful auto-scan of the registration marks.
To be precise, it doesn't lock up until I click "OK" on this little popup:
Re: Print and Cut: Software locks up after successful auto-s
http://craftedge.com/support/support_form.html
Please contact support directly through this form or via email.
Please contact support directly through this form or via email.
My pictures and files are available for a limited time only.
-
dragonlord666
- Posts: 499
- Joined: Tue Jun 05, 2012 1:18 pm
Re: Print and Cut: Software locks up after successful auto-s
it sounds like bad communication, but I would contact craftedge as mentioned above and see what they say
Gaz
Gaz
Cutters: Phoenix Silver Bullet 18", Black Cat Cougar 18", Silhouette Cameo & Cameo 4
Software: SCAL 5 Pro, Inkscape, Gimp
Computer:IMac running Mojave