TIMING OUT TOO SHORT

papasue
Posts: 4397
Joined: Sun Mar 16, 2008 2:08 pm
Location: CALIFORNIA
Contact:

Re: TIMING OUT TOO SHORT

Post by papasue »

Perhaps it is time to contactcraftedge support directly. They can work with the silver bullet folk to figure it out.

http://CraftEdge.com/support/support_form.html
Susan E
http://creationsbypapasue.blogspot.com
LEARN, GROW, CREATE, SHARE


Mac 10.12.6 Sierra, eCAL 1.506, ECAL2.023, SCAL4Pro, Export Plug-in, Inkscape 48, iPad/scal3
eClips2.
Shab
Posts: 13
Joined: Thu Oct 18, 2012 7:55 am

Re: TIMING OUT TOO SHORT

Post by Shab »

Gaz,

What you say about the cable is a bit discouraging, for a moment there I thought the Keyspan cable will solve all the problems. In any event, I am pretty happy with the method I found and I will wait until the software is updated to address this problem properly.

Thanks,

Shab
Shab
Posts: 13
Joined: Thu Oct 18, 2012 7:55 am

Re: TIMING OUT TOO SHORT

Post by Shab »

papasue wrote:Perhaps it is time to contactcraftedge support directly. They can work with the silver bullet folk to figure it out.

http://CraftEdge.com/support/support_form.html
Susan,

I contacted CraftEdge twice, this was their first reply:

"The cutter itself automatically resets itself after a period of inactivity. We have been working on an update to prevent the cutter from automatically resetting itself.

Sincerely
- The Craft Edge Team
http://www.craftedge.com"

I have not received yet a reply to my second attempt to discuss the issue with them.

Shab
Shab
Posts: 13
Joined: Thu Oct 18, 2012 7:55 am

Re: TIMING OUT TOO SHORT

Post by Shab »

About two hours ago I got fantastic news from the Craft Edge Team folks:
----------------------------------------------------------------------
Hi Shab
We are looking to release an update this week to fix that issue

Sincerely
- The Craft Edge Team
http://www.craftedge.com
-----------------------------------------------------------------------
If the fix works, it will be the answer to all the issues above and we can relax a bit. I know I will.

Shab
dragonlord666
Posts: 499
Joined: Tue Jun 05, 2012 1:18 pm

Re: TIMING OUT TOO SHORT

Post by dragonlord666 »

The keyspan will improve things, I was just pointing out the time out is there no matter what happens (OK so now craft edge have increased it, but it's still there) Serial is a way better communication than usb.

Gaz
Image
Cutters: Phoenix Silver Bullet 18", Black Cat Cougar 18", Silhouette Cameo & Cameo 4
Software: SCAL 5 Pro, Inkscape, Gimp
Computer:IMac running Mojave
Post Reply