Craft Edge

Sure Cuts A Lot Forum
It is currently Wed Apr 08, 2020 6:55 am

All times are UTC - 8 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Fri Mar 06, 2020 6:18 pm 

Joined: Fri Mar 06, 2020 6:08 pm
Posts: 1
Attachment:
File comment: SCALP5 octagon
SCAL5P1.PNG
SCAL5P1.PNG [ 12.26 KiB | Viewed 230 times ]
Attachment:
File comment: Easy cut octagon
EasyCut.PNG
EasyCut.PNG [ 9.1 KiB | Viewed 230 times ]
Attachment:
File comment: Basic arrow
SCAL5P2.PNG
SCAL5P2.PNG [ 22.14 KiB | Viewed 230 times ]
I just switched from Easy Cut to SCALP5. everything looks ok until I go to cut or draw. depending on the item I get leading and trailing lines. I have overcut set to 0. in SCAL5P2 the pen goes from start point to the 5 cutting through the arrow, on the Octagon it is leading and trailing cuts.
Anyone know if there is a setting or adjustment somewhere. (ignore the size difference. I didn't think to make exact size, but doesn't matter.)
This example is with a pen, because I already ruined a decal...

Using Saga cutter


Top
 Profile  
 
PostPosted: Sun Mar 08, 2020 7:36 am 

Joined: Mon May 09, 2011 7:01 am
Posts: 806
Even though you responded on Facebook that you figured it out, I thought I'd go ahead and answer here what you discovered. There are two Saga cutters available in SCAL's menu of cutters: Saga and Saga ARMS. The wrong one was selected in SCAL.

_________________
Sandy McCauley
Owner of http://www.iloveknk.com/


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group